Describe a process you would use to create the perpendicular bisect or to a segment ab using only an unmarked straightedge and an unmarked compass

How would you write the name of a segment differently than the name of a line? what symbols would you use? How is constructing a perpendicular bisector similar to constructing an angle bisector? how is it different? Describe a process you would use to create the perpendicular ...

See explanation below.

Step-by-step explanation:

The process would be as it follows:

Place the compass point at one end of the segment.Then, adjust the compass to be larger than half the segment (you don't really need to measure this, you can do it by sight).With this width of the compass, draw two arcs, one above the segment and one below the segment.Now, move the compass to the other end of the segment and place the point of the compass in the other end.Without adjusting the width you use on the other end, draw two arcs again, one above the segment and one below the segment.This arcs will cross and form two "x" ( one above and one below the segment)Now take your unmarked straightedge and draw a line that passes through where the arcs intersect. This line that you just draw perpendicularly bisects the segment AB.

f(x) < 0 over the intervals (–infinity, –2.7) and

(–1, 0.8).

Step-by-step explanation:

I got it right