Gababon
11.07.2021 •
Engineering
a cylindrical metal block of mass 0.5kg is heated electrically by a 45W heater for 20°C to 85°C during this period. determine its specific heat capacity.
Solved
Show answers
More tips
- F Food and Cooking How to salt lard?...
- W Work and Career Can Skill Alone Make You a Professional?...
- C Computers and Internet How to Top Up Your Skype Account Without Losing Money?...
- P Philosophy Unidentified Flying Object - What is the Nature of this Phenomenon?...
- F Family and Home Protect Your Home or Apartment from Pesky Ants...
- O Other What is a Disk Emulsifier and How Does it Work?...
- F Family and Home What does a newborn need?...
- F Family and Home Choosing the Right Car Seat for Your Child: Tips and Recommendations...
- F Food and Cooking How to Get Reconfirmation of Registration?...
Answers on questions: Engineering
- E Engineering When driving, your hand position should be at 10 and 2 3 and 6 9 and 5 8and 4...
- E Engineering Toughness, hardness at high temperatures, and wear resistance is required for a crankshaft. which steel would you select? (a)- sae 1302 (b)-sae 1017 (c)-sae 4042 (d)-sae...
- E Engineering Select the best steel alloy for a corrosion resistant sheet metal parts. strength is not critical, but low cost is important. (a)-sae 3122 (b)-sae 2052 (c)-sae 3114 (d)-sae...
- E Engineering The system for a chain of gas stations is composed of a point of sale system and a fuel delivery system. the point of sale system is composed of one or more cashier stations,...
- E Engineering An ideal reheat rankine cycle with water as the working fluid operates the boiler at 15,000 kpa, the reheater at 2000 kpa, and the condenser at 100 kpa. the temperature...
- E Engineering The flow rate of liquid metal into the downsprue of a mold = 0.7 l/sec. the cross-sectional area at the top of the sprue = 750 mm^2, and its length = 185 mm. what area should...
- E Engineering When removing the balance shaft assembly: technician a inspects the bearings for unusual wear or damage. technician b smoothens a damaged camshaft or balance shaft journal...
- E Engineering Asteam power plant operates on a simple ideal rankine cycle between the pressure limits of 3 mpa and 50 kpa. the temperature of the steam at the turbine inlet is 300°c,...
- E Engineering Apiston-cylinder device contains 6.95 kg of refrigerant-134a at 0.6 mpa and 70°c. the refrigerant is now cooled at constant pressure until it exists as a liquid at 22°c....
- E Engineering Steam is to be condensed on the shell side of a heat exchanger at 120°f. cooling water enters the tubes at 63°f at a rate of 102.6 lbm/s and leaves at 77°f. assuming the...
Ответ: