Why were people with Japanese ancestry interned during World War II? Japanese Americans wanted to flee the west coast of the US to be safer inland.
Most Japanese Americans wanted to avoid being drafted by Japan’s military.
People feared those with Japanese ancestry would support Japan in the war.
Many Japanese Americans tried to return to Japan at the start of the war.

The correct response is: People feared those with Japanese ancestry would support Japan in the war.

Explanation:

The policy the US government adopted after Pearl Harbour occurred was to move anyone of Japanese descent into internment camps, where they were expected to remain for the duration of WWII.  This affected 120,000 Japanese-Americans by confiscating their property and belongings and forcing them into camps located in different regions around the country. The Japanese Americans were sent to live in what were called relocation centers, which were located in remote parts of western states and Arkansas. Their treatment there was a lot like being in prison: their movements were restricted by armed guards and they had to be present at roll call. They were kept inside the grounds with barbed wire fencing.  It was a decision based largely on unspoken prejudices against Asian immigrants because there was no incarceration of people with German or Italian ancestry.

Orthographic Projection is used for making the projects but Isometric Projection is used to have better understanding of the object.

Orthographic drawings are typically two dimensional views of an object. For instance, if you were designing a table, you would draw a top view, side view and a bottom view. Should these three views not fully explain the design of the table other views would need to be drawn. When drawing an perspective view in an orthographic manner, you would utilize a 45 degree triangle for the lines that extend back or forward from the vertical lines. This type of perspective is not a true perspective because you can measure the true length of all the details shown. An isometric drawing is meant to depict a 3D image of an object in what appears to be a perspective view. However, similar to an orthographic perspective, all of the lines in an isometric drawing can be measured to their true length. What makes it different from an orthographic perspective is that its angled lines are drawn at 30 or 60 degrees or divisions of them. Drawing this by hand you would use a 30/60/90 triangle.

In either case, both types of perspectives can be accurately measured with a ruler in order to know the objects measurements.

Step-by-step explanation: