In a mechanics experiment, a student picks up four different discs with different radii and sets them in uniform circular motion. For each disk, the tangential speed of a point near the outside edge is recorded. The recorded values for are inconsistent. Disk Speed Radius Acceleration
1 57 cm/s 20 cm 163 cm/s2
2 40 cm/s 10 cm 190 cm/s2
3 95 cm/s 40 cm 226 cm/s2
4 70 cm/s 30 cm 163 cm/s2

(a) The elevator is traveling upward and its upward velocity is decreasing as it nears a stop at a higher floor.  T > mg

(b) The elevator is traveling upward and its upward velocity is increasing as it begins its journey towards a higher floor. T > mg

(c) The elevator is traveling downward and its downward velocity is decreasing as it nears a stop at a lower floor. T < mg

(d) The elevator is traveling downward at a constant velocity. T = mg

(e) The elevator is traveling downward and its downward velocity is increasing. T < mg

(f) The elevator is stationary and remains at rest. T = mg

Explanation:

To answer this question, consider all the forces acting on the elevator.

The mass of the ball acting downwards due to gravity = mg

The tension on the string depends on upward or downwards force on the ball. T = m(a+g)

where a is acceleration and increase in velocity causes increase in acceleration, and vice versa. (a = v/t)

(a) The elevator is traveling upward and its upward velocity is decreasing as it nears a stop at a higher floor.

If the upward velocity is decreasing, its acceleration is also decreasing, and acceleration is not equal to Zero

T = m(a+g) > mg

(b) The elevator is traveling upward and its upward velocity is increasing as it begins its journey towards a higher floor.

If the upward velocity is increasing, its acceleration is also increasing.

Then, T = m(a+g) > mg

(c) The elevator is traveling downward and its downward velocity is decreasing as it nears a stop at a lower floor.

If the downward velocity is decreasing, its acceleration is also decreasing, and acceleration is not equal to Zero

T = m(a-g) < mg

(d) The elevator is traveling downward at a constant velocity

At constant velocity, acceleration is zero, because acceleration is the rate of change of velocity.

T = m(0+g) = mg

(e) The elevator is traveling downward and its downward velocity is increasing

If the downward velocity is increasing, its acceleration is also increasing

T = m(a-g) < mg

(f) The elevator is stationary and remains at rest.

if the elevator is at rest, its acceleration is zero

T = m(0+g) = mg